Pro-Max / Max Applications

Fast Off® Pad Attachment
View Video Demo 1

For heating sheet metal through plastic trim, decals, moldings, and appliqués. Softens the adhesive, allowing quick, easy removal and salvage of parts bonded to metal. Greatly reducing the need for toxic solvents and other expensive consumables.

Remove:

Body trim (backing stays intact)

Name plates and emblems

Vinyl graphics

Weather stripping

After market stainless trim

Pre-heat cold metal panels instantly

Use for installation for all the above

Spray-on bed liners

Glass Blaster® Attachment
View Video Demo 1
View Video Demo 2
Large magnetic inductor coil

Used for removing urethane-bonded windows. Glass Blaster can get to those hard to reach areas were other glass tools can’t (deep pockets and tight curves), eliminating the collateral damage normally associated with conventional glass tools.

A little Flameless Heat, a little outward pressure, all the way around and it's out. Operates completly from outside the glass.
Uses:

Removal of glass / *composite panels bonded to metal and Spray-On Bed Liners

*(i.e.; Camaro/Firebird roof panels)

Concentrator® Attachment
View Video Demo

The Concentrator can be used for loosening rusted nuts/bolts, heat shrinking, hail dent removal. Think of it as a flameless torch tip.

Uses:

Hail dent removal (no special attachment needed)

Metal shrinking

Fabricating

Release Thread Lock Compounds

Easily remove seam sealers in a fraction of the time!

Helps eliminate the need for expensive consumables!

Loosen seized fasteners & connectors

ROSEBUD^TM Attachment
View Video Demo
Midly Heat Aluminum & Heavier Guaged Steels or 1/4" plate steel red hot in seconds, if needed.

As with all Heat Inductors, the heat is localized with this attachment. Creating a safer enviroment and help preventing the collateral damage normaly associated with an open flame.

This attachment has a replaceable heat shield and can be used without air for; short term high heat applications on steel, long term low heat applications (adjustable power control) on steel or when working with aluminum. When working with aluminum the heat sheild can be removed for even greater power!

Working with steel for long term high heat applications air cooling is recommended for protecting the longevity of the product! (air regulator / guage included)

Uses: frame rails, annealing aluminum prior to repairs, removing decals from aluminum,. fabricating steel...

Tech Tips: With any type of induction heat, there may be some heat transfer to the adjascent surface of which you are heating that could distort some plastics. One may want to consider either pulling these parts back from the suface or use our Cold Shield Thermal Shield Spray Gel for a little insurance.

Tech Tips: Some of the metals found in newer vehicles today have alloys such as Boron Steel that should not be heated. One should identify these metals before heating. Below are a couple of helpful links.

http://www.i-car.com/

http://www.ussautomotive.com/auto/tech/grades/grades_home.htm