Menu

Induction Heating Tools

Extinguish the Flame

Steering Bolt Removal

Using the Mini-Ductor® Induction Heater & Flameless Torch

Removing rusted, corroded or locked steering bolts is often a lengthy, difficult and frustrating task, especially if using a ratchet wrench. It usually requires the application of penetrating fluid or blasting the area with a torch – this is time consuming, can cause unwanted damage and it's a potential risk to your safety.

How Does It Work?

The Mini-Ductor handheld induction heating tool heats metal parts in seconds. This allows all types of adhesives bonded to metal, fasteners bonded with thread lock compound, and seized hardware, to be removed and released much quicker and safer than by traditional naked flame heating.

Using a torch leads to heat being blown away from the load, wasting its energy and transferring its heat to unwanted areas. With the Mini-Ductor nearly all the energy pulled is applied to the load, using INVISIBLE HEAT®, making the tool faster and more energy efficient.

Safely Increase Productivity by 50%

Mechanics do not need to run the risk of using a torch which could damage the CV joint, rubber grommets, or the rotor.

The Mini-Ductor coils come in different diameters to suit different nut sizes and the Bearing Buddy flexible, heat resistant coil is ideal for this application (see images below).

Induction heating provides a safer, quicker and less damaging alternative to naked flame heating and a great return on investment. Apart from the increased safety benefits, the use of the Mini-Ductor can increase a garage's fastener extraction productivity by over 50%.

Step-by-Step Instructions

  • Equipment needed: heat resistant gloves, overalls, goggles and a respirator mask (if smoke will be produced from heating)
  • Knowledge required: a well-reviewed proficiency of the Mini-Ductor's safety and operating instructions

Step 1: Clean area with wire brush. Remove dirt and grease.

Steering Bolt Removal 1

Step 2: Wrap the steering bolt with the Bearing Buddy Coil.

Steering Bolt Removal 2

Step 3: Attach the Mini-Ductor.

Steering Bolt Removal 3

Step 4: Heat the Bearing Buddy Coil.

Steering Bolt Removal 4

Step 5: Remove the Bearing Buddy Coil.

Steering Bolt Removal 5

Step 6: Select tool for loosening the steering bolt.

Steering Bolt Removal 6

Step 7: The steering bolt is loosened easily.

Steering Bolt Removal 7

Contact us to learn more about removing steering bolts with induction heating

Induction Innovastions, Inc.
Induction Heating Tools & Equipment Made in the USA

U.S. patents: 6670590 and 6563096 apply to all products; D707,804 and D728,086 apply to handheld, inline induction heaters; patent pending for the Mini-Ductor 12V (MD-500)
European Patent Office (EPO): patent 002076372-0001 applies to all handheld, inline induction heaters; patent pending for the Mini-Ductor 220V (MD-800) and Mini-Ductor 12V (MD-500)
Australia patent: 343968 applies to all handheld, inline induction heaters